Effects of Drill Vibrations on Cutting Forces and Torque

CIRP Annals - Manufacturing Technology

Volumn 43, Issue 1, 1994, Pages 59-62

  Rincon, Diana M ^a   Ulsoy, A Galip ^a   Kaftanoĝlu, Bilgin ^a  

^a NONE

Author keywords

Cutting; drilling; vibrations

Indexed keywords

DRILLING; DRILLS; FINITE ELEMENT METHOD; FORECASTING; MACHINE VIBRATIONS; MATHEMATICAL MODELS; PERFORMANCE; TORQUE;

BURR FORMATION; CHISEL EDGE; CUTTING EDGE; CUTTING FORCES; LOBED HOLES; TOOL BREAKAGE; TRANSLATIONAL MOTION;

CUTTING;

EID: 0027962270     PISSN: 00078506     EISSN: 17260604     Source Type: Journal    
DOI: 10.1016/S0007-8506(07)62164-7     Document Type: Article

References (30)

1. “Predictive Models for Drilling Thrust and Torque - a Comparison of three Flank Configurations,”
2. “Computerized End-Milling Force Predictions with Cutting Models Allowing for Eccentricity and Cutter Deflections,”
3. “An Investigation of the Cutting Mechanisms of the New Point Drill,”
4. “Chatter Vibration in Drilling,”
5. Cylindrical Flank Twist Drill Points
6. Whirling Vibration in Drilling. Part 1: Cause of Vibration and Role of Chisel Edge
7. Whirling Vibration in Drilling. Part 3: Vibration Analysis in Drilling Workpiece with a Pilot Hole
8. “Some Experiments on the Influence of Various Factors on Drill Performance,”
9. “Drill Point Geometry and Optimization,”
10. “An Analysis of the Drill Wandering Motion,”
11. “Vibration Modes and Frequencies of Twist Drills Using Laser Holographic Interferometry,”
12. “Buckling Loads and Natural Frequencies of Twist Drills,”
13. “Investigation into Drilling Laminated Printed Circuit Board Using a Torque-Thrust Temperature Sensor,”
14. “Effects of Chip Splitting Nicks in Drilling,”
15. “On the Drilling of Metals I: Basic Mechanics of the Process,”
16. “The Torque and Thrust Arising From Contact at the Lips in Spade Drilling of Ductile Metals,”
17. “Mathematical Model for Multifaceted Drills,”
18. “Computer Models for the Mechanics of Three-Dimensional Cutting Processes -Part I: Theory and Numerical Method, Part II: Results for Oblique End Turning and Drilling,”
19. “Modeling and Finite Element Analysis of Drill Bit Vibrations,”
20. Effects of Geometric and Process Parameters on Drill Transverse Vibrations
21. “Computer-assisted Prediction of Drill-failure Using In-process Measurements of Thrust Force,”
22. “Dynamic Modeling of Transverse Drill Bit Vibrations,”
23. “Thrust and Torque Prediction in Drilling from a Cutting Mechanics Approach,”
24. “Comprehensive Dynamic Cutting Force Model and Its Application to Wave-Removing Processes,”