A Current-Sourced DC-DC Converter Derived via the Duality Principle from the Half-Bridge Converter

IEEE Transactions on Industrial Electronics

Volumn 40, Issue 1, 1993, Pages 139-144

  Wolfs, Peter J ^a  

^a CENTRAL QUEENSLAND UNIVERSITY   (Australia)

Author keywords

[No Author keywords available]

Indexed keywords

BRIDGE CIRCUITS; ELECTRIC INDUCTORS; ELECTRIC WINDINGS; POWER SUPPLY CIRCUITS;

BOOST CONVERTER CHARACTERISTICS; CENTER-TAPPED TRANSFORMER CONVERTER; CURRENT-SOURCED DC-DC CONVERTER; CURRENT-SOURCED SWITCHED-MODE POWER SUPPLY TOPOLOGY; DUALITY PRINCIPLE; HALF-BRDGE CONVERTER; INDUCTOR CLAMPING WINDINGS; NONDISSIPATIVE SNUBBER NETWORKS;

ELECTRIC CONVERTERS;

EID: 0027544998     PISSN: 02780046     EISSN: 15579948     Source Type: Journal    
DOI: 10.1109/41.184830     Document Type: Article

References (13)

1. C. A. Desoer and E. S. Kuh, Basic Circuit Theory. New York: McGraw-Hill, 1969, pp. 455–456.
2. N. Balabanian and T. A. Bickart, Electrical Network Theory. New York: Wiley, 1969, pp. 118–122.
3. S. Cuk, “General topological properties of switching structures,” IEEE PESC Conf Rec. 1979, pp. 109–130.
4. H. Foch, P. Marty, and J. Roux, “Use of duality rules in the conception of transistorized converters,” in Proc. APEC Conf. Rec. 1980, pp. 4B.3-1-4B.3-11.
5. R. P. Severns and G. E. Bloom, Modem DC to DC Switchmode Power Converter Circuits. New York: Van Nostrand Reinhold, 1985, Ch. 9.
6. S. Freeland, “Techniques for the practical application of duality to power circuits,” in Proc. IEEE PESC Conf. Rec. 1989, pp. 114–122.
7. A. Block, “On method for the construction of networks dual to non-planar networks,” Proc. Physical Soc., vol. 58, pp. 677–694, 1946.
8. R. Redl and N. O. Sokal, “Push-pull current-fed multiple-output regulated wide-input-range dc/dc power converter with only one inductor and with 0 to 100% switch duty ratio: Operation at duty ratio below 50%,” in Proc. IEEE PESC Conf Rec. 1981, pp. 204–212.
9. V. J. Thottuvelil, T. G. Wilson, and H. A. Owen, “Analysis and design of a push-pull current fed converter topology,” in Proc. IEEE PESC Conf. Rec. 1981, pp. 192–203.
10. R. Redl and N. O. Sokal, “Push-pull current-fed multiple-output regulated wide-input-range dc/dc power converter with only one inductor and with 0 to 100% switch duty ratio,” in Proc. IEEE PESC Conf. Rec. 1980, pp. 341–345.
11. P. Tenti, L. Rossetto, L. Malesani, R. Borgatti, and R. Stefani, “Single-stage current-fed dc to dc converter with time-sharing control of output voltage and input current,” IEEE Trans. Power Electron., vol. 5, no. 4, pp. 389–397, Oct. 1990.
12. A. Boehringer and H. Knoll, “Transistorschalter im Bereich Hoher Leistungen und Frequenzen,” Elektrotechnische Zeitschr., Heft 100, pp. 664–670, Jan. 1979.
13. J. D. van Wyk and J. A. Ferreiria, “Transistor inverter optimization in the frequency range above 5 kHz up to 50 kVA,” IEEE Trans. Industry Applications, vol. IA-19, no. 2, pp. 296–302, March/April 1983.