Equilibrium dihedral angles in the system quartz-CO2H2ONaCl at 800°C and 1-15 kbar: the effects of pressure and fluid composition on the permeability of quartzites

Earth and Planetary Science Letters

Volumn 114, Issue 1, 1992, Pages 171-184

  Holness, Marian B ^a  

^a UNIVERSITY OF EDINBURGH   (United Kingdom)

Author keywords

[No Author keywords available]

Indexed keywords

DIHEDRAL ANGLE; FLUID COMPOSITION; PERMEABILITY; PRESSURE; QUARTZITE;

EID: 0027089455     PISSN: 0012821X     EISSN: None     Source Type: Journal    
DOI: 10.1016/0012-821X(92)90159-S     Document Type: Article

References (24)

1. Direct observation of near-equilibrium pore geometry in synthetic quartzites at 600–800°C and 2–10.5 kbar
2. Solid-liquid interfacial tensions by the dihedral angle method. A mathematical approach
3. 2O fluids and their implications for fluid transport, host rock physical properties, and fluid inclusion formation
4. Intergranular distribution of pore fluid and the nature of high-angle grain boundaries in limestone and marble
5. The effect of fluid chemistry on wetting textures in novaculite
6. 2NaCl-calcite, and implications for fluid flow during metamorphism
7. A unifying theory of the stability of penetrating liquid phases and sintering pores
8. Permeabilities interfacial areas and curvatures of partially molten systems results of numerical computations of equilibrium microstructures
9. Properties of texturally equilibrated two-phase aggregates
10. Grains, phases and interfaces: an interpretation of microstructure
11. Development and maintenance of metamorphic permeability: implications for fluid transport
12. Dihedral angle measurement
13. Measurement of dihedral angles
14. 2O fluids for use in hydrothermal experimentation I. Experimental method and equilibrium calculations in the COHN system
15. Carbon monoxide—uninvited guest at the piston cylinder party
16. 2O
17. 2 component on the low quartz-coesite transition
18. 2O
19. Tension interfaciale solide-liquide des systèmes AlSn, AlIn, et AlSnIn
20. Surface energy and adsorption at mineral/water interfaces: an introduction
21. The ratio of grain boundary energy to surface energy of nuclear ceramics as determined from pore geometries
22. 2O to 1000°C and 10,000 Bars
23. Characterization of aqueous colloids by their electrical double layer and intrinsic surface chemical properties