Effect of the Hydrodynamic Bearing on Rotor/Stator Contact in a Ring-Type Ultrasonic Motor

IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control

Volumn 39, Issue 6, 1992, Pages 675-682

  Maeno, Takashi ^a   Bogy, David B ^a  

^a UNIVERSITY OF CALIFORNIA   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

AIR LUBRICATION; BEARINGS (MACHINE PARTS); DESIGN; FRICTION; HYDRODYNAMICS; NUMERICAL ANALYSIS; ROTORS; STATORS;

AIR BEARINGS; HYDRODYNAMIC BEARINGS; ROTOR STATOR CONTACT; ULTRASONIC MOTORS;

ULTRASONIC DEVICES;

EID: 0026942870     PISSN: 08853010     EISSN: None     Source Type: Journal    
DOI: 10.1109/58.165550     Document Type: Article

References (7)

1. T. Maeno, T. Tsukimoto, and A. Miyake, “Finite-element analysis of the rotor/stator contact in a ring-type ultrasonic motor,” IEEE Trans. Ultrason., Ferroelec., Freq. Contr., vol. 39, no. 6, pp. 668–674, 1992.
2. T. Maeno, T. Tsukimoto, and A. Miyake, “Study on the contact mechanism of an ultrasonic motor,” JSME Spring Annu. Meeting, 1990 Japanese).
3. E. O. J. Salbu, Trans. ASME D, vol. 86, no. 2, pp. 335, 1966.
4. K. Ono, “Analysis and its experimental verification of motion of mass supported on compressible squeeze film,” Trans. Japan Soc. Lubrication Eng. vol. 21-9, p. 589, 1976 (in Japanese).
5. J. W. White and A. Nigam, “A factored implicit scheme for the numerical solutions of the reynolds equation at very low spacing,” ASME J. Lubr. Tech., vol. 102, no. 1, pp. 80–85, Jan. 1980.
6. D. Miu, “Dynamics of gas-lubricated slider bearings in magnetic recording disk files: Theory and experiment,” Ph. D. dissertation, Univ. Calif., Berkeley, Dept. Mech. Eng., 1985.
7. D. Miu and D. B. Bogy, “Dynamics of gas-lubricated slider bearings in magnetic recording disk files—Part II: Numerical simulation,” ASME J. Tribology, vol. 108, p. 589, 1986.