메뉴 건너뛰기




Volumn 283, Issue 3, 1989, Pages 590-595

Development of the CRID single-electron wire detector

(45)  Aston, D a   Bean, A c   Bienz, T a   Bird, F a   Caldwell, D c   Cavalli Sforza, M d   Coyle, P d   Coyne, D d   Dasu, S a   Dunwoodie, W a   Hallewell, G a   Hasegawa, K g   Huber, J c   Jacques, P f   Johnson, R A e   Kawahara, H a   Kwon, Y a   Leith, D a   Lu, A c   Martinez, J e   more..


Author keywords

[No Author keywords available]

Indexed keywords

IMAGING TECHNIQUES; SPECTRUM ANALYSIS;

EID: 0024769908     PISSN: 01689002     EISSN: None     Source Type: Journal    
DOI: 10.1016/0168-9002(89)91421-6     Document Type: Article
Times cited : (9)

References (15)
  • 2
    • 84913941255 scopus 로고    scopus 로고
    • The blinds are made by PCM Products Inc., Titusville, FL 32780, USA.
  • 9
    • 84913931640 scopus 로고
    • The amplifier used was the MOSFET preamp PC board prototype (BF992 at front end) followed by a differential receiver (NE5539). The total gain of the system was about 2.4 μV/electron.
    • (1987) SLAC-PUB-4404
    • Spencer1
  • 11
    • 84913928427 scopus 로고    scopus 로고
    • The 7 μm wires are made by Toho Rayon Co., Tokyo, Japan.
  • 12
    • 84913922060 scopus 로고    scopus 로고
    • The 33 μm wires are made by Textron Specialty Material Co., Lowell, MA 01851, USA.
  • 14
    • 84913916949 scopus 로고    scopus 로고
    • The UV xenon lamp L2435 is made by Hamamatsu Co.; the trigger circuit is made at SLAC; the UV gun delivers about 400 Hz with time jitter of 20 ns.


* 이 정보는 Elsevier사의 SCOPUS DB에서 KISTI가 분석하여 추출한 것입니다.