Measurement of Loop Gain with the Digital Modulator

IEEE Transactions on Power Electronics

Volumn PE-1, Issue 1, 1986, Pages 55-62

  Cho, B H ^a   Lee, Fred C Y ^a  

^a VIRGINIA POLYTECHNIC INSTITUTE AND STATE UNIVERSITY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

CONTROL, ELECTRIC VARIABLES - CURRENT; INSTRUMENTS, DIGITAL; MODULATORS - SWITCHING;

CURRENT INJECTED CONTROL; DIGITAL MODULATION; FEEDBACK LOOP GAIN;

ELECTRIC MEASUREMENTS;

EID: 0022563257     PISSN: 08858993     EISSN: 19410107     Source Type: Journal    
DOI: 10.1109/TPEL.1986.4766277     Document Type: Article

References (12)

1. R. D. Middlebrook, “Measurement of loop gain in feedback sys-tem,” nt. J. Electron., vol. 38, pp. 485–512, Apr. 1975.
2. R. D Middlebrook, “Predicting modulator phase lag in PWM converter feedback loops,” presented at Power Con. 8, 1981.
3. D. J. Shortt, “An improved swithing converter model,” Ph.D. the-sis, ‘ Virginia Polytechnic Inst. and State Univ., Blacksburg, VA.
4. F. C. Lee and R. A. Carter, “Investigations of stability and dynamic performances of switching regulators employing current-injected control,” in Proc. IEEE Power Electronic Specialist Conf., 1981.
5. F. C. Lee, Y. Yu, and M. F. Mahmound, “A unified design procedure for a standardized control module for dc-dc switching regulators,” in Proc. IEEE Power Electronics Specialist Conf., 1980.
6. S. Hsu, “Problems in analysis and design of switching regulators,” Ph.D. thesis, California Inst. of Technol., Pasadena, 1979.
7. R. D. Middlebrook and S. Cuk, “A general unified approach to modeling switching converter power stages,” in Proc. IEEE Power Elec-tronics Specialist Conf., 1976.
8. S. P. Hsu, A. Brown, L. Rensink, and R. D. Middlebrook, “modeling and current-programmed of switching dc to dc converters in constant frequency analysis mode,” in Proc. IEEE Power Electronics Specialist Conf., 1979.
9. A. Brown, “Topics in the analysis, measurement, and design of highperformance performance switching regulators,” Ph.D. thesis, California Inst. Technol., Pasadena, 1981.
10. C. W. Deisch, “Simple switching control method changes power converter into current source,” in Proc. IEEE Power Electronic Conf., 1978.
11. Z. D. Fang, T. H. Lee, and F. C. Lee, “Some design considerations of switching regulators employing current injected control,” PCI, 1983.
12. R. Saucedo and E. Schiring, Introduction to Continuous and Digital Control Systems. New York: Macmillan, 1968.