Experimental and theoretical investigation of mechanical disturbances in epoxy-impregnated superconducting coils. 1. General introduction

Cryogenics

Volumn 25, Issue 6, 1985, Pages 304-306

  Iwasa, Y ^a  

^a MASSACHUSETTS INSTITUTE OF TECHNOLOGY   (United States)

Author keywords

epoxy resin; introduction; superconducting magnets

Indexed keywords

CRYOGENICS - PLASTICS APPLICATIONS; EPOXY RESINS - LOW TEMPERATURE EFFECTS;

FILLER MATERIAL; FLUX JUMPS; IMPREGNATION; QUENCHING;

SUPERCONDUCTING MAGNETS;

EID: 0022076109     PISSN: 00112275     EISSN: None     Source Type: Journal    
DOI: 10.1016/0011-2275(85)90013-X     Document Type: Article

References (38)

1. Flux compression in hard superconductors
2. 3Sn
3. Training and degradation phenomena in superconducting magnets
4. Superconducting coil training and instabilities due to the Bauschinger effect
5. Investigation of the training problem of superconducting magnets
6. Thermomechanical heat generation in copper and a NbTi superconducting composite
7. An attempt to reduce training
8. Dynamic stress effects in technical superconductors and the ‘training’ problem of superconducting magnets
9. Fermilab Doubler magnet design and fabrication techniques
10. Microslip-induced degradation in a braided superconductor
11. The mechanism of friction motion and its effect at 4.2 K in superconducting magnet winding models
12. Mechanical disturbances for a cable-in-substructure superconductor
13. Mechanical disturbances in Rutherford-type and braid conductors
14. Magnet system of the 500 MHz NMR spectrometer at the Francis Bitter National Magnet Laboratory: I. Design and development of the magnet
15. Stresses in superconducting solenoids, Mechanics of Superconducting Structures
16. A solution to the ‘training’ problem in superconducting magnets
17. Superconducting coils impregnated with Wood's metal
18. The effect of adhesion between turns on the training of superconducting magnets
19. Training of epoxy-impregnated superconducting windings
20. Magnet System of the 500 MHz NMR spectrometer at the Francis Bitter National Magnet Laboratory: II. Disturbances, quenches, and training
21. An attempt to reduce training using filled epoxy as an impregnating material
22. MIT/Francis Bitter National Magnet Laboratory program to assess superconductor stability
23. Frictional properties of metal-insulator interface
24. Frictional properties of metalinsulator surfaces at cryogenic temperatures
25. Frictional disturbances in superconducting magnets
26. Heat generation from epoxy cracks and bond failures
27. Stress-induced epoxy cracking and energy release at 4.2 K in epoxy-coated superconducting wires
28. Acoustic emission in superconductors and superconducting magnets and its diagnostic potential
29. Origins of acoustic emission in superconducting wires
30. Identification of quench origins in a superconductor with acoustic emission and voltage measurements
31. Acoustic emission triangulation of disturbances and quenches in a superconductor and a superconducting magnet
32. Sources of acoustic emission in superconducting magnets
33. Acoustic emission monitoring results from the MFTF magnets
34. Correlation of acoustic emission with normal zone occurrence in epoxy-impregnated windings: An application of acoustic emission diagnostic technique to pulse superconducting magnets