Active Reflector for Radar Calibration

IEEE Transactions on Geoscience and Remote Sensing

Volumn GE-22, Issue 2, 1984, Pages 165-169

  Brunfeldt, David R ^a   Ulaby, Fawwaz T ^a  

^a 343 Nichols Hall   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

RADAR EQUIPMENT;

EID: 0021389061     PISSN: 01962892     EISSN: 15580644     Source Type: Journal    
DOI: 10.1109/TGRS.1984.350610     Document Type: Article

References (7)

1. P. Blacksmith, Jr., R. E. Hiatt, and R. B. Mack, “Introduction to radar cross-section measurements,” Proc. IEEE, vol. 53, pp. 901-920,1965.
2. F. T. Ulaby, R. K. Moore, and A. K. Fung, Microwave Remote Sensing: Active and Passive, Vol. I: Microwave Remote Sensing Fundamentals and Radiometry. Reading, MA: Addison-Wesley, 1981.
3. E. L. Johansen, “Top-hat reflectors cap radar calibration,”Microwaves, vol. 20, pp. 65–66, 1981.
4. L. C. Van Atta, “Electromagneticreflector,” U.S. Patent 2 908 002, 1959.
5. T. Larsen, “Reflector arrays,” IEEE Trans. Antennas Propagat., vol. AP-14, no. 6, pp. 689–693, 1966.
6. D. R. Brunfeldt and F. T. Ulaby, “Active reflector for radar calibration,” Univ. of Kansas Remote Sensing Lab., Lawrence, KS, Tech. Rvdkvep. 460-11,1982.
7. A. D. Goldfinger, “Seasat SAR processor signatures: Point targets,” Applied Physics Lab., Johns Hopkins Univ., Laurel, MD, Rep. CP-078.