Analysis of tool temperature fluctuation in interrupted cutting

Precision Engineering

Volumn 6, Issue 2, 1984, Pages 99-105

  Chakraverti, G ^b   Pandey, P C ^b   Mehta, N K ^a  

^a INDIAN INSTITUTE OF TECHNOLOGY ROORKEE   (India)

^b NONE

Author keywords

cutting tools; interrupted cutting; temperature distribution; temperature rise; thermal stress

Indexed keywords

STRESSES;

HARMONIC HEAT FLUX; INTERRUPTED CUTTING; TOOL FAILURE;

METAL CUTTING;

EID: 0020117002     PISSN: 01416359     EISSN: None     Source Type: Journal    
DOI: 10.1016/0141-6359(84)90043-6     Document Type: Article

References (33)

1. Influence on tool life and power of nose radius, chamfer and peripheral cutting edge angle when face milling a 40 000 psi cast iron
2. Thermal state of tool cutting edge in intermittent cutting
3. Thermal crack in the carbide face milling cutter
4. Thermal stress resistance of some carbide and oxide tool materials
5. Carbide tool life at interrupted cut with continuous cycles
6. Machining steel with a carbide tipped tool in intermittent heavy cutting conditions
7. Failure of carbide tools in intermittent cutting
8. Influence of thermal cycling on tool life in peripheral milling
9. Efficiency of cutting tools in intermittent cutting conditions
10. Contact stresses in intermittent cutting proocess
11. An investigation of wear in single tooth and multitooth milling
12. Fracture of cemented carbide tools in face milling
13. Failure of cemented carbide tools in intermittent cutting
14. Effect of thermal and adhesion phenomena on tool life in interrupted machining
15. Chip-tool adhesion in intermittent cutting
16. The assessment of tool life in peripheral milling
17. The exist failure in interrupted cutting
18. High speed films of the incipient cutting process in machining at conventional speeds
19. Temperature distribution at the tool-chip interface in metal cutting
20. Temperature in orthogonal metal cutting
21. Cutting tool temperature predicting equation by response surface methodology
22. On the temperature distribution in orthogonal machining
23. A remote thermocouple method for estimating temperatures in machining
24. Measurement of cyclic temperature change of tool-chip interface in carbide fly milling
25. Performance of cemented carbide tools in intermittent cutting
26. An analysis of thermal cracking of carbide tools in intermittent cutting
27. Tool temperature in intermittent cutting
28. Internal temperature distribution of the carbide fly cutting tool
29. Temperature and adhesion in continuous and interrupted machining
30. Study on tool failure of carbide tools in interrupted turning
31. Cracking behaviour of sintered carbides during edm