The optimization problem with optimal tolerance assignment and full acceptance

Journal of Mechanical Design, Transactions of the ASME

Volumn 103, Issue 4, 1981, Pages 842-848

  Michael, W ^a   Siddall, J N ^a  

^a MCMASTER UNIVERSITY   (Canada)

Author keywords

[No Author keywords available]

Indexed keywords

FITS AND TOLERANCES - ANALYSIS;

OPTIMIZATION;

EID: 0019625884     PISSN: 10500472     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.3254996     Document Type: Article

References (7)

1. Bjorke, O., Computer-Aided Tolerancing, Topic Publishers, 1978.
2. Bandier, J. W., “Optimal Centering Tolerancing and Tuning in Engineering Design,” Internal report in Simulation, Optimization and Control, No. SOC-177, Faculty of Engineering, McMasterUniv., Canada, 1977.
3. Faupel, J. H Engineering Design, Wiley, 1964.
4. Michael, W., Optimal Tolerance Allocation,” Ph.D. thesis, McMaster Univ., Canada, 1980.
5. Siddall, J. N., “‘OPTIVAR’ Designers’ Optimization Subroutines,” Faculty of Eng., McMasterUniv., Canada, 1979.
6. Himmelblau, D. M Process Analysis by Statistical Methods, Wiley, 1970.
7. Peat, A. P., Cost Reduction Charts for Designers and Production Engineers, The Machining Publishing Co. Ltd., Brighton, 1968.