Measurement of the axial residual stresses using the initial strain approach

Journal of Engineering Materials and Technology, Transactions of the ASME

Volumn 122, Issue 1, 2000, Pages 135-140

  Cheng, Weili ^a  

^a Berkeley Eng and Research Inc   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 0011508231     PISSN: 00944289     EISSN: 15288889     Source Type: Journal    
DOI: 10.1115/1.482777     Document Type: Article

References (12)

1. Cheng, W., and Finnie, I., 1994, “An Overview of the Crack Compliance Method for Residual Stress Measurement,” SEM, Proceedings of the Fourth International Conference on Residual Stresses, pp. 449-458.
2. Cheng, W., and Finnie, I., 1998, “The Single-Slice Method for Measurement of Axisymmetric Residual Stresses in Solid Rods or Hollow Cylinders in the Region of Plane Strain,” ASME Journal of Engineering Materials and Technology, Vol. 120, pp. 170-176.
3. Finnie, I., and Cheng, W., 1996, “Residual Stress Measurement by the Introduction of Slots or Cracks,” Localized Damage IV, Nisitani et al., eds. Computation Mechanics Publications, pp. 37-51.
4. Fung, Y. C., 1965, Foundations of Solid Mechanics, Prentice-Hall, Englewood Cliffs, NJ.
5. Prime, M. B., 1991, “Experimental Verification of the Crack Compliance Method,” M.S. project report, University of California, Berkeley.
6. Prime, M. B., 1999, “Residual Stress Measurement by Successive Extension of a Slot: The Crack Compliance Method,” Appl. Mech. Rev., Vol. 52, pp. 75-96.
7. Timoshenko, S. P., and Goodier, J. N., 1970, Theory of Elasticity, 3rd edition, McGraw-Hill, New York.
8. Johnson, D., and Johnson, J., 1982, Mathematical Methods in Engineering and Physics, Prentice-Hall, Englewood Cliffs, NJ.
9. Mayville, R., and Finnie, I., 1982, “Uniaxial Stress-Strain Curves from a Bending Test,” Experimental Mechanics, Vol. 22, p. 197.
10. Ueda, Y., Fukuda, K., and Kim, Y. C., 1986, “New Measuring Method of Axi-symmetric Three-Dimensional Residual Stresses Using Inherent Strains as Parameters,” ASME Journal of Engineering Materials and Technology, Vol. 108, pp. 328-334.
11. Ueda, Y., and Fukuda, K., 1989, “New Measuring Method of Three-Dimensional Residual Stresses in Long Welded Joints Using Inherent Strains as Parameters-Lz Method,” ASME Journal of Engineering Materials and Technology, Vol. 111, pp. 1-8.
12. Ueda, Y., Murakawa, H., and Ma, N. X., 1996, “Measuring Method for Residual Stresses in Explosively Clad Plates and a Method of Residual Stress Reduction,” ASME Journal of Engineering Materials and Technology, Vol. 118, pp. 576-582.