New methods for detecting physical phenomena in a silo

KONA Powder and Particle Journal

Volumn 16, Issue May, 1998, Pages 229-240

  Hatamura, Yotaro ^a   Takeuchi, Takatsugu ^a   Nakao, Masayuki ^a  

^a UNIVERSITY OF TOKYO   (Japan)

Author keywords

[No Author keywords available]

Indexed keywords

ATMOSPHERIC TEMPERATURE; CYTOLOGY;

FRICTIONAL STRESS; INTERNAL TEMPERATURE; MEASUREMENTS OF; PARALLEL PLATES; PHYSICAL PHENOMENA; PRESSURE CELL; SURFACE TEMPERATURES; TWO-DIRECTIONAL;

CELLS;

EID: 0006260590     PISSN: 02884534     EISSN: 21875537     Source Type: Journal    
DOI: 10.14356/kona.1998026     Document Type: Article

References (22)

1. Richards P. C.: "Bunker design (1)," Trans ASME Ser. B. 99-4, 809 (1977).
2. Rotter J. M.: "Structural design of light-gauge silo hoppers." J. Am. Conr. Inst., 88, 443 (1990).
3. Sugita M.: "Flow and pressure of non cohesive granular materials in deep bin," J. Soc. Powder Technol. Japan, 7, 513 (1970).
4. Dumbaugh G. D.: "Flow from bulk-solids storage bins," Chem. Eng., 86, 189 (1979).
5. Jenke A. W. and J. R. Johanson: "Bin loads-Part 2, 3, 4," J. Eng. Ind., Feb., 1 (1973).
6. Nguyen TY., C. Brennen and R. H. Sabersy: "Gravity flow of granular materials in conical hoppers," Trans ASME, J. Appl. Mech., 46, 529 (1979).
7. Okamoto H.: "Experimental investigation by acoustic method on flow noise of granular mass," J. Fac. Eng., Univ. Tokyo, XXXVI, 37 (1981).
8. HidakaJ., A. Shimosaka and S. Miwa: "The effect of the particle properties on the parameter of impact sound between two particles," J. Soc. Powder Technol. Japan, 24, 151 (1985).
9. Sindel J. A.: "Temperature differentials in the wall of a clinker-filled silo." J. Am. Cone. Inst., 82, 73 (1985).
10. Askegard V. and J. Munch-Andersen: "Results from tests with normal and shear stress cells in a mediumscale model silo," Powder Technol., 44, 151 (1985).
11. Schulze D. and C. Lyle: "Die Entwickung einer Fuenfkomponenten-Spannungsmesszelle fuer Spannungsmessungen und Silos," Messtech Briefe, 24, 33(1988).
12. Schulze D. and C. Lyle: "A new load cell for measuring normal and shear stresses," Chem. Eng. Technol., 12, 318 (1989).
13. Hatamura Y. & T Takeuchi: "A proposal for intelligent silo based on measured phenomena," Proc. of Sec. World cong. Tech., Tokyo, japan, Sep. 19-22 (1990).
14. Hatamura Y. & T Takeuchi: "A new detecting method of granular stresses acting on the silo wall," Proc. of the First Inti. Conf on MCGM, Syenyang of China, Sep. 288 (1982).
15. Hatamura Y.: "Development of pressure cell for granular materials," Prepr. J. Soc. Mech. Eng. Japan, 825-5, 7 (1982).
16. Takeuchi T & Y. Hatamura: "Development of 2-directional stress cell for granular materials," Prepr. J. Soc. Mech. Eng. japan, 827-2, 171 (1982).
17. Nakao M., T Okumura, Y. Hatamura, Nagao T and Ikeda G.: "Development of deformation sensor for extract change of structure." Prepr. J. Soc. Free. Eng. Japan, k24, 411 (1993).
18. Okamoto H. & Y. Hatamura: "Development of slipping velocity meter using power spectrum of sound pressure," Prepr. J. Soc. Mech. Eng. japan, 827-2, 171 (1982).
19. Syoji M.: "Study on an inverse problem of transient heat conduction," Trans. jSME, 44-381, 1633 (1978).
20. Hatamura Y., T Takeuchi & H. Okamoto: "A trial of surface temperature detector for granular materials," Prepr. J. Soc. Mech. Eng. Japan, 827-2, 233 (1982).
21. Hatamura Y., T Takeuchi & H. Okamoto: "A trial of inner temperature/velocity meter for granular material," Prepr. J. Soc. Mech. Eng. Japan, 807, 182 (1982).
22. Okamoto H.: "Analysis of power spectrum of soundpressure on flow noise of grain using simple equipment," Prepr. J. Soc. Mech. Eng. japan, 820-14, 168 (1982).