Polymer-Derived Ceramic Coatings on C/C-SiC Composites

Journal of the European Ceramic Society

Volumn 16, Issue 10, 1996, Pages 1115-1120

  Bill, J ^a   Heimann, D ^a  

^a UNIVERSITY OF STUTTGART   (Germany)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 0001095827     PISSN: 09552219     EISSN: None     Source Type: Journal    
DOI: 10.1016/0955-2219(96)00025-8     Document Type: Article

References (21)

1. Hüttinger, K. J. & Greil, P., Keramische Verbundwerkstoffe für Höchsttemperaturanwendungen. DKG 69, 2 (1989) 395-400.
2. Schanz, P. & Krenkel, W., Description of the mechanical and thermal behavior of liquid siliconized C/C. Presented at 6th European Conf. on Composite Materials ECCM, Bordeaux, September 1993.
3. Oberflächen- und Dünnschicht-Technologie Teil I, ed. R. A. Haefer. Springer-Verlag, 1987.
4. Wynne, K. J. & Rice, R. W., Ceramics via polymer pyrolysis. Ann. Rev Mater., 14 (1984) 297-334.
5. Lipowitz, J., Polymer-derived ceramic fibres. Ceram. Bull., 70[12] (1991) 188-193.
6. Mucalo, M. R., Milestone, N. B., Vickridge, I. C. & Swain, M. V., Preparation of ceramic coatings from pre-ceramic precursors. J. Mater. Sci., 29 (1994) 4487-4499.
7. Riedel, R., Passing, G., Schönfelder, H. & Brook, R. J., Synthesis of dense silicon-based ceramics at low temperatures. Nature, 355 (1992).
8. Sakka, S. & Yoko, T., Sol-gel derived coating films and applications. Structure and Bonding, 77 (1992) 89-117.
9. Dislich, H. & Hussmann, E., Amorphous and crystalline dip-coating obtained from organometallic solutions: procedures, chemical process and products. Thin Solid Films, 77 (1981) 129-139.
10. Landau, L. & Levich, B., Dragging of a liquid by a moving plate. Acta Physicochim. U.R.S.S., XVII, [1-2] (1942) 42-54.
11. Nichimen Corporation, NCP 200 Data sheet, 13-1 Kyobashi 1-chome, Tokyo 104, Japan.
12. Krenkel, W. & Gern, F., Microstructure and characteristics of CMC manufactured via the liquid phase route. Presented at 9th Int. Conf. on Composite Materials, Madrid, Spain, 12-16 July 1993.
13. Vogel, K., Messung der Schichtdicke von Lackierungen und ähnlichen Beschichtungen, Prüftechnik bei Lackherstellung und Lackverarbeitung. Fachbuchreihe 'Lackiertechnik' der Zeitschrift 'Industrie Lackierbetrieb', Vol. 2, Curt R. Vincentz Verlag, Hannover, 1992, pp. 7-12.
14. Sickfield, J. & Raabe, H. J., Beurteilung der Haftfestigkeit durch Abreißversuch nach DIN ISO 4624. Farbe + Lack, 87[8] (1981) 653-655.
15. Coblenz, W. S., Wiseman, G. H., Davis, P. B. & Rice, R. W., Formation of ceramic composites and coatings utilizing polymer pyrolysis. Mater. Sci. Res., (1984) 271-285.
16. Schönfelder, H., Siliciumcarbidnitridkeramik aus Polysilazan. PhD thesis, University Stuttgart, 1992.
17. Seibold, M. & Greil, P., Thermodynamics and microstructural development of ceramic composite formation by active fillercontrolled pyrolysis (AFCOP). J. Eur. Ceram. Soc., 11 (1993) 105-113.
18. Hutchinson, J. W. & Suo, Z., Adv. Appl. Mech., 28 (1991) 126-149.
19. Bill, J., Aldinger, F. & Heimann, D., Oberflächenschutz von Si-infiltriertem SiC. DFG-Zwischenbericht für den Sonderforschungsbereich 259, 'Hochtemperaturprobleme rückkehrfähiger Raumtransportsysteme', March 1994.
20. Heimann, D., Bill, J. & Aldinger, F., Herstellung oxidationsbeständiger, keramischer Schutzschichten durch Polymer-Pyrolyse. Presented at the General Meeting of the Deutsche Gesellschaft für Materialkunde, Göttingen, Germany, 24-27 May 1994.
21. Bill, J., Kienzle, A., Sasaki M., Riedel, R. & Aldinger, F., Novel routes for the synthesis of materials in the quaternary system Si-B-C-N and their characterisation. Proc. World Ceramic Congress, Florence, Italy, 20 June-4 July 1994 (in press).